Stroboscope: 100-10,000 FPM (DS2239) Xenon Flash with Case

$229.95

http://inspectusa.com/stroboscope-10010000-ds2239-xenon-flash-with-case-p-1217.html

Add Qty to Cart:

Quantity Discounts
1	2-5	6-11	12-23	24+
$229.95	$218.45	$206.96	$195.46	$183.96

	Product 6 of 11
Category Tachometer / Strobes

This stroboscope is a microprocessor circuit design, high accuracy, digital readout, light duty STROBOSCOPE/TACHOMETER that is ideal for INSPECTING and measuring the speed of moving gears, fans, centrifuges, pumps, motors and other equipment used in general industrial maintenance, production, quality control, laboratories and as well as for schools and colleges for demonstrating strobe action. 110-120vAC or battery powered.

Features:

Range 100 to 10,000 rpm
Xenon flash tube
Housing: Compact and impact plastic injection case with plastic mirror type reflector
Display: 10mm Red LED
A/C or battery operation

Specifications:

Display: 10mm Red LED
Stroboscopic flash rate: 100 to 10,000 flashes per minute (FPM)
Resolution:
- 1 FPM/RPM Less than 10,000 FPM/RPM
- 10 FPM/RPM Over 10,000 FPM/RPM
Accuracy:
- ±1 digit from 100 to 5,000 FPM/RPM
- ± 0.05% over 5000 FPM/RPM
Sampling Time: 1 second
Power Supply: 110vAC ± 10%, 50/60 Hz
Power Consumption: Less than 30 Watts
Flash Tube: Xenon lamp
Flash Duration: Approximately 60 to 1,000 microseconds
Flash color: Xenon white 6,500 ° K
Flash energy: 4 Watts-seconds (joules)
Beam Angle: 80
Operating Duty Cycle: (for prolong life and safe operation. please adhere to the following duty cycle)
- Below 1,000 RPM: 30 Minutes
- Above 3,600 RPM: 5 Minutes
Always allow a 10 minute cooling off period between cycles
Operating humidity range: <80%
Operating temperature range: 32° to 122° F (0° to 50° C)
Dimension (HxWxD): 8.3" x 4.8" x 4.8" (210 x 12x 12cm)
Weight: 2.2 LB (1Kg)

Operation:

Preparation:
- (a) Plug unit into a properly grounded 110V AC, 220V AC or 230V AC outlet.
- (b) Turn the power switch to “on” position.
- (c) Determine the range switch to “Low” or “High” position.
Checking Speed:
- When checking speed, care must be taken to insure that the strobe is flashing in unison (one to one) with the
  object being monitored.
- A Stroboscope will also stop motion at 2:1.3:1,4:1 et., this is normally referred to as
  harmonies. To be sure of unison. turn the dial until two images appear – this will double the actual speed. Then
  lower the flashing rate until a single and stationary image appears – this is the actual true speed.
Checking Motion: For motion analysis, simply locate the actual speed as mentioned above and then turn the dial slowly up or down.
This will give a slow motion effect allowing complete inspection.