Versa Test Complete Inspector Test Kit to 24' Reach (VT-COMPLETE) Test Smoke & Heat Detectors

• The Perfect Service & Maintenance Test Kit to Test Smoke and CO Detectors
• UL/ULC Listed, Registered #372844, #3728441, #3728383
• The easiest way to Meet NFPA 72 and International Fire Code Compliance
• Versa-Test™ Dispenser Accepts Multiple Can Sizes
• Versa-Poles™ are Durable, Lightweight, Non-Conductive Fiberglass

Supplied with:

• (1) VT-1 Aerosol Dispenser
• (1) VP-16 16' Telescoping Test Pole
• (1) VP-4X 4' Extension pole
• (1) VP-8 8' Telescoping Test Pole
• VT-694 Heat detector tester kit
  • HC-94 Heat Detector Cup
  • HA-94 Heat Detector Adapter
  • VP- Adapter
  • (6) Heat Pads
  • (2) Saline Pillows
  • Saline Syringe
• VT-OD Open Delivery Kit
  • (1) N-30 30" Aluminum Test Head
  • (1) N-59 50" Aluminum Extension Pole
• (1) 1490 18" Aerosol extension tube
• Adapter Professional Equipment Bag

Instructions for Use

• Remove bottom cup by screwing it counter clockwise
• Snap fit aerosol can into the cusp with the nozzle up
• Screw aerosol cup with can in place clockwise into base unit, until aerosol is slightly released
• Unscrew the cup counter clockwise approximately half a turn to eliminate the pressure on nozzle
• Insert yoke end of dispenser into end of Versa-Pole. For additional reach add the VP-4X Adapter to top of VP-16 and insert dispenser into the adapter
• Placing the open end of chamber over the detector, ensure a tight seal to the ceiling Press upwards on the pole to engage. Only slight upwards pressure is required to release the appropriate amount of gas to activate the alarm’s sensor.
• Remove chamber from alarm to clear the sensing chamber.