Raven Pour-N-Seal (68153) 2-Part Epoxy Bonding Adhesive
$159.00
Quantity Discounts |
1 | 2-5 | 6-11 | 12-23 | 24+ |
$159.00 | $157.41 | $154.23 | $151.05 | $147.87 |
HIGH-STRENGTH EPOXY BONDING ADHESIVE
POUR-N-SEAL™ is a gray two-part
medium viscosity high strength epoxy used to seal around multiple pipe
penetrations in tight areas where pipe boots are not practical, when installing
VaporBlock® moisture and gas barriers.
TECHNICAL DATA
Applicable Standards:
- ASTM (American Society for Testing and Materials).
- ASTM C881
Standard Specification for Epoxy-Resin-Base Bonding Systems for Concrete.
- ASTM
D695 Standard Test Method for Compressive Properties of Rigid Plastics.
- ASTM
D638 Standard Test Method for Tensile Properties of Plastics.
- ASTM C882
Standard Test method for Bond Strength of Epoxy-Resin Systems Used with Concrete
by Slant Shear.
- ASTM Standard Test Method for Deflection Temperature of
Plastics Under Flexural Load in the Edgewise Position.
- ASTM D570 Standard Test
Method for Water Absorption of Plastics.
MATERIAL PREPARATION
Store
material overnight to precondition at a temperature between 70° F to 80° F prior
to use.
INSTALLATION
POUR-N-SEAL™ is used to seal moisture and gas
barriers to multiple pipe penetrations in situations where pipe boots are not
able to be installed due to the tight concentration of the pipe penetrations.
Install the vapor/gas barrier as close as possible to the penetrations by making
a small opening. Effort should be given to minimize large gaps in the barrier
next to the penetrations, this will also reduce the amount of POUR-N-SEAL™
necessary to complete an acceptable seal.
To help concentrate the sealant
around the pipe penetration, a dam can be formed around the pipe grouping with
an adhesive backed weather stripping foam. One gallon covers 80 sq. ft. at a
thickness of 20 mils.
- Only mix the amount of material that can be used within the pot life of the
epoxy, approximately 36 minutes at 73° F. Premix each component prior to
combining. Pour “A” and “B” components together and thoroughly mix using a low
speed drill with a mixing paddle. Scrape the sides and bottom to assure a
consistent blend.
- Once mixed, pour contents around the pipe penetrations, if needed a brush or
flat wooden stick can be used to direct the sealant completely around all
penetrations and overlap the moisture/gas barrier to form a continuous seal.
Avoid Contact with skin (see SDS for complete safety precautions). Immediately
dispose of any remaining mixed POUR-N-SEAL™ epoxy left in the container to avoid
excessive heat buildup.
- Depending upon the temperature. POUR-N-SEAL should be tack free in
approximately 5 hours.
STORAGE/SHELF LIFE
Store in dry environment between 40º F and 80º F (4º C-27º C). Do not allow
product to freeze. Shelf Life: 12 months from date of manufacture in unopened
containers properly stored. Protect from moisture.
POUR-N-SEAL™ same as Part Number: PNS1G.