Reference only — this item is no longer available. This product has been discontinued and cannot be ordered. We keep the page online so the specifications and documentation stay available to anyone still running the equipment. Current replacements are listed further down.

Discontinued

HSI Carbon Monoxide Alarm Testing Kit (CAT-KIT)

Reference only — not for sale

Model	CAT-KIT
Manufacturer	Home Safeguard
Category	Carbon Monoxide
Status	Discontinued

Browse all Carbon Monoxide Ask us for a replacement

Product details (archived)

The information below is retained for reference only. This item is discontinued and cannot be ordered.

SOLD BY THE CASE ONLY - 12 pack

Home Safeguard's completely self-contained Carbon Monoxide test kit, Model #: CAT-KIT is supplied with everything you need to perform routine functional testing of your CO Detectors while they remain in place, whether they are wall or ceiling mounted; battery powered or hard-wired.

Due to FEDERAL LAWS, this product cannot be shipped via US Postal Service or any other Air Method - at checkout you will only be offered UPS GROUND as the shipping method.

Light weight - weighs less than 1pound.
Aerosol can contains 2800ppm of Carbon Monoxide GWP of less than 1 (.016)
CoCheck and the CaT Kit are uL classified
The top cover of package is your enclosed delivery tool
100% Natural, contains only materials found in the air we breathe
Environmentally friendly
Made in USA, patent pending

IMPORTANT: When opening package be careful not to rip, or cut the top cover. This cover is intended to become the enclosure for the test.

Kit includes:

can COCheck aerosol
extension straw
Testing enclosure
Testing instructions

Manufacturer's INSTRUCTIONS:

This test kit is intended for functional testing of Carbon Monoxide Detectors, battery operated or hardwired.

When opening package, do not rip or cut top cover. This cover will be used as the testing enclosure (device). Set cover aside.
Remove cap from the can and insert attached straw into the push button (actuator).
Take reserved cover and place over CO Alarm on wall. *Low tack tape will hold cover in place.
Insert open end of straw, (while attached to can) into are marked with an "X" cut-out.
Spray entire contents of can thru the straw into the enclosure.
Most properly functioning alarms should sound with 10-25 seconds.
NOTE: Some alarms are set for longer saturation testing. This could take from 90 seconds to 5 minutes)

After completion of test, the remaining carbon monoxide within the test device cover, is of a low concentration. It is not dangerous and will dissipate in a matter of moments. Dispose of cover and empty can in non-recyclable refuse container.

KEEP OUT OF REACH OF CHILDREN.

Download MSDS (Material Safety Data Sheet)