You have just had your home, or a property your are thinking of buying, tested for radon and the level is near or exceeds 4.0 PicoCuries/Liter (pCi/L). Now what? What do you do? Is it safe for you and your family to be in the home?
The first step is don’t panic. Radon levels can be reduced. Your next step should be to gather information. If you know more about radon, its causes and remedies, you will understand how to formulate a strategy to reduce the radon level. Let’s begin the education process by answering some basic questions:
When should I be concerned? The United States Environmental Protection Agency (EPA) recommends that you take action to reduce your home’s indoor radon levels if your radon test result is 4 pCi/L or higher. Be advised that recently the World Health Organization has lowered the corrective level to 2.7 pCi/L. It is recommended to correct a radon problem before placing your home on the market since you would have more time to address the issue.
How does radon enter the home? The radon in your home’s indoor air can come from two sources, the soil or your water supply. Compared to radon entering your home through water, radon entering your home through soil is a much larger risk. If you’ve tested for radon in air and have elevated radon levels and your water comes from a private well, have your water tested. The devices and procedures for testing your home’s water supply are different from those used for measuring radon in air.
The radon in your home’s indoor air can come from two sources, the soil or your water supply. Compared to radon entering your home through water, radon entering your home through soil is a much larger risk. If you’ve tested for radon in air and have elevated radon levels and your water comes from a private well, have your water tested. The devices and procedures for testing your home’s water supply are different from those used for measuring radon in air.
Radon in the water supply poses an inhalation risk and an ingestion risk. Research has shown that your risk of lung cancer from breathing radon in air is much larger than your risk of stomach cancer from swallowing water with radon in it. Most of your risk from radon in water comes from radon released into the air when water is used for showering and other household uses.
A radon in water problem is more likely when its source is ground water, e.g. a private well or a public water supply system that uses ground water. Some public water systems treat their water to reduce radon levels before it is delivered to your home. When your water supply comes from surface water then radon is usually a not problem. If you are concerned that radon may be entering your home through the water and your water comes from a public water supply, contact your water supplier.
Don’t worry if you’ve tested your private well and have a radon in water problem, it can be fixed. Your home’s water supply can be treated in one of two ways. Point-of-entry treatment can effectively remove radon from the water before it enters your home. Point-of-entry treatment usually employs either granular activated carbon (GAC) filters or aeration devices. While GAC filters usually cost less than aeration devices, filters can collect radioactivity and may require a special method of disposal. Point-of-use treatment devices remove radon from your water at the tap, but only treat a small portion of the water you use or the water you drink. Point-of-use devices are not effective in reducing the risk from breathing radon released into the air from all water used in the home.
Can high radon levels be reduced? The short answer is yes, radon levels can be reduced in a home by installing a radon mitigation system or by making some repairs to your home.
What do I need to do? Your first step should be to retest your home using a long-term radon test kit. Long term tests usually last from three to 12 months. (Long-term radon test kits can be purchased here. LINK) Since radon levels can fluctuate, long-term tests provide an average level of radon in your home over a greater period of time. Therefore, long-term tests are more accurate than the short-term tests. If the long-term test results show the radon level is still over 4pCi/L than you should consider repair and remediation to your home.
A variety of methods can be used to reduce radon in homes. Sealing cracks and other openings in the foundation is a basic part of most approaches to radon reduction. The EPA does not recommend the use of sealing alone to limit radon entry. Sealing alone has not been shown to lower radon levels significantly or consistently.
In most cases, a system with a vent pipe(s) and fan(s) is used to reduce radon. These “sub-slab depressurization” systems do not require major changes to your home. Similar systems can also be installed in homes with a crawl space. These systems help to prevent radon gas from entering the home from below the concrete floor and from outside the foundation. Radon mitigation contractors may use other methods that may also work in your home. The right system depends on the design of your home and other factors.
Techniques for reducing radon are discussed in the EPA’s “Consumer’s Guide to Radon Reduction.” As with any other household appliance, there are costs associated with the operation of the radon mitigation system. Also, please keep in mind that any mitigation measures taken or system installed in your home must conform to your state’s regulations. In states without regulations covering mitigation, the system should conform to the EPA’s Radon Mitigation Standards.
How do I find a radon mitigation contractor? Select a qualified radon mitigation contractor to reduce the radon levels in your home just as you would for any other home repair. You may want to get more than one estimate, ask for and check their references. Make sure the person you hire is qualified to install a mitigation system. Some states regulate or certify radon mitigation services providers. Be aware that a potential conflict of interest exists if the same person or firm performs the testing and installs the mitigation system. Some states may require the homeowner to sign a waiver in such cases. When the same person or firm performs the testing and mitigation, make sure the testing is done in accordance with the EPA’s Radon Testing Checklist. Contact your state radon office for more information. Your Inspect USA customer service representative may be able to provide you with a list of independent, certified, insured and experienced radon mitigation service firms. Note: It is recommend you always obtain quotes from multiple vendors who are licensed and insured whenever service is required.
What will a qualified radon mitigation contractor do for me? A qualified radon mitigation contractor should be able to:
- Review the radon test results before beginning any mitigation work to determine if additional measurements are needed.
- Evaluate the radon problem and provide you with a detailed, written proposal on how radon levels may be lowered.
- Design a radon-reduction system.
- Install the system according to EPA standards and/or state or local codes.
- Verify that the finished system effectively reduces radon levels to acceptable levels.
What do I do after the radon mitigation system is installed? After a mitigation system is installed, re-test the property to verify that the radon gas levels have been reduced. If your living patterns change and you begin occupying a lower level of your home (such as a basement) you should retest your home on that level. In addition, it is a good idea to retest your home sometime in the future to be sure radon levels remain low. We recommend you consider buying a continuous radon monitor that can be used to verify the proper functioning of your mitigation system. A monitor will measure the radon levels 24 hours a day and sound an alarm if the radon level goes above 4 pCi/L. Inspect USA offers a very accurate and dependable Continuous Radon Detector & Alarm for less than $200, which is equivalent to about 6 or 7 separately performed, do-it-yourself short term tests when considering kit prices, shipping and lab fees.
Will the seller pay for remediation? If elevated levels are found during the real estate transaction, the buyer and seller should discuss the timing and costs of the radon reduction. The cost of making repairs to reduce radon levels depends on how & even when the home was built, as well as other factors. Most homes can be fixed for about the same cost as other common home repairs, like painting or having a new water heater installed. The average cost for a contractor to lower radon levels in a home can range from $800 to about $2,500 according to EPA estimates.
What else do I need to know? If you are planning any major renovations, such as converting an unfinished basement area into a living space, it is especially important to test the area for radon before you begin. If your test results indicate an elevated radon level, radon-resistant techniques can be inexpensively included as part of the renovation. Major renovations, seismic events, settling and excavation can change the level of radon in any home. Test again after any work or events have occurred. For a full list of InspectUSA radon test kits, visit this link. https://inspectusa.com/radon-gas-testing-kits-c-27.html