Reference only — this item is no longer available. This product has been discontinued and cannot be ordered. We keep the page online so the specifications and documentation stay available to anyone still running the equipment. Current replacements are listed further down.

Discontinued

Phosphate in Water Test Kit 0 to 10 ppm (AQ-12063) 120 Tests

Reference only — not for sale

Model	12063
Manufacturer	National Safety
Category	Water Testing
Status	Discontinued

Browse all Water Testing Ask us for a replacement

Product details (archived)

The information below is retained for reference only. This item is discontinued and cannot be ordered.

This kit allows you to easily and accurately measure the phosphate level and maintain a healthy aquarium or pond. Enough to perform approximately 150 tests.

Kit contains: two dropper bottles for accurate dispensing of test solutions, easy to read instructions and color charts, one non-staining glass test tube with snap-tight cap.

Range is as follows for freshwater and saltwater: 0.0 PPM, 0.5 PPM, 1.0 PPM, 2.0 PPM, 5.0 PPM, 10.0 PPM.

Instructions:
Fill the test tube with 5ml of water to be tested (to the line on the tube). Add 6 drops from Test Solution bottle #1 to the test tube, holding the dropper bottle upside down in a completely vertical position to assure uniformity of drops added to the water sample.

Cap and shake the test tube vigorously for 5 seconds.

Add 4 drops for Test Solution Bottle #2 to the test tube, holding the dropper bottle upside down in a completely vertical position to assure uniformity of drops added to the water sample. Bottle #2 has very thick solution and may require increased pressure while squeezing to release drops.

Cap and shake the test tube vigorously for 5 seconds.

Wait 3 minutes for full color to develop.

After the 3 minutes, read the test results by matching the test solution against the appropriate Phosphate Test Color Chart. The tube should be viewed against the white area beside the color chart.

Color comparisons are best made in a well-lit area. The closest match indicates the PPM (mg/l) of total phosphate in the water sample.

Rinse the test tube with clean water after each use.